Beko WITV8712 XW0 Manuel D'utilisation page 23

1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake valves. Clean them with
an appropriate brush. If the filters are too dirty, take them out by means of pliers and clean them.
3. Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean
thoroughly under running water.
4. Replace the gaskets and filters carefully in their places and tighten the hose nuts by hand.
4.4.5 Draining remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and fabric fibers clogging the
pump impeller during discharge of washing water. Thus, the water will be discharged without any problem and
the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is clogged or
in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house) and in case of freezing of
the water, water may have to be drained completely.
A
WARNING:
In order to clean the dirty filter and discharge the water:
1. Unplug the machine to cut off the supply power.
A
WARNING:
cleaned after the water in the machine cools down.
2. Some of our products have emergency draining hose and some does not have. Follow the steps below to
discharge the water.
Discharging the water when the product does not have an emergency draining hose:
a. Place a large container in front of the filter to catch water from the filter.
b. Loosen pump filter (anticlockwise) until water starts to flow. Fill the flowing water into the container you
have placed in front of the filter. Always keep a piece of cloth handy to absorb any spilled water.
c. When the water inside the machine is finished, take out the filter completely by turning it.
4. Clean any residues inside the filter as well as fibers, if any, around the pump impeller region.
5. Install the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and then press the upper part to close.
Washing Machine / User's Manual
Foreign substances left in the pump filter may damage your machine or may cause noise problem.
Temperature of the water inside the machine may rise up to 90 ºC. To avoid burning risk, filter must be
23 / EN