AcceleDent OPTIMA Mode D'emploi page 21

IMMUNITY Test
Electrostatic discharge
(ESD) IEC 61000-4-2
Electrical fast transient/
burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and
voltage variations on
power supply input lines
IEC 61000-4-11
Power frequency (50/60
Hz) magnetic field IEC
61000-4-8
NOTE: UT is the A.C. mains voltage prior to application of the test level.
10.15.2. Electromagnetic Immunity Part 2
10.15.2.1. The Activator is intended for use in the electromagnetic
environment specific below. The customer or the user of the Activator
should assure that it is used in such an environment.
EC60601 Test
I
Level
±8 kV contact
±2, 4, 8, 15 kV air
± 2 kV for power supply
lines ± 1 kV
for input/output lines
± 1 kV line(s) to line(s)
± 2 kV line(s) to earth
100% drop,
0.5 periods, 0º, 45º, 90º,
135º, 180º, 225º, 270º,
315º
100% dip,
1 period
30% dip,
25/30 periods
Voltage
Interruptions
(all input current)
30 A/m
BACK TO CONTENTS
Compliance Level Electromagnetic
Environment -
Guidance
±8 kV contact Floors should be wood,
± 2 kV, ± 4 kV, ± 8 kV, ± 15 concrete or ceramic tile.
kV air If floors are covered with
synthetic material, the
relative humidity should
be at least 30%.
± 2 kV for power supply Mains power quality
lines ± 1 kV for input/ should be that of a typical
output lines domestic environment.
Mains power quality
± 2 kV common mode should be that of a typical
domestic environment.
100% drop, Mains power quality
0.5 periods, 0º, 45º, 90º, should be that of a
135º, 180º, 225º, 270º, typical domestic
315º environment
100% dip,
1 period
30% dip,
25/30 periods
100% drop, 5 seconds
30 A/m Power frequency
magnetic fields should
be at levels characteristic
of a typical domestic
environment.
Tested in X, Y, and Z
axes.
Can be waived due
to a justification that
there are no magnetic
components. Assumes a
minimum distance of 15
cm to magnetic source
in actual usage
21
Page of 51