Perel LEDA402 Série Mode D'emploi page 6

5. Overview
Refer to the illustrations on page 2 of this manual.
1 mounting bracket
2 hinge
6. Installation
Guidelines
 A qualified technician should install and service this device.
 The construction to which the device is attached should be able to
support 4 times the weight of the device for one hour without
deformation.
 Never stand directly below the device when it is being mounted,
removed or serviced. Have a qualified technician check the device once a
year and once before you bring it into service.
 Overhead mounting requires extensive experience: calculating workload
limits, determining the installation material to be used... Have the
material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper
installation may result in serious injuries.
 This device is not suitable for dimming.
Distances
 Keep at least 50 cm distance at the top and 30 cm on either side.
 Respect a minimum distance of 0.5 m between the device's light output
and any illuminated surface.
Suitable Mounting Positions
on the floor
Mounting the Lamp
1. This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
2. Use the mounting bracket [1] to determine the location of the mounting
holes.
3. Drill the holes and secure the bracket using screws and wall plugs.
V. 01 – 16/06/2014
LEDA402 Series
3 protective glass
4 power cable
on a wall
6
on the ceiling
©Velleman nv