Bosch SHE89PW55N Notice D'utilisation page 37

Masquer les pouces Voir aussi pour SHE89PW55N:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Switching off the appliance
Short time after the end of the wash
cycle:
Press On/Off button (.
1.
Turn off water supply.
2.
Remove the utensils when they
3.
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
Open the door.
1.
Switch off On/Off switch (.
2.
The LED's go out. The wash cycle
is saved.
To continue the wash cycle,
3.
switch on the On/Off switch (
again.
Close the door.
4.
Operating the Dishwasher en-us
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Cancel a cycle (reset)
Open the door and press and
1.
hold the Start button )" for
approximately 3 seconds until the
digital display @ shows:
"Program was terminated".
Close the door.
2.
Wait about 1 minute while the
3.
dishwasher drains.
Open the door and press the
4.
On/Off switch (.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
37

Publicité

Chapitres

Table des Matières
loading

Table des Matières