Bosch SHE65T52UC Notice D'utilisation page 30

en-us Operating the Dishwasher
Delay start
You can delay the start of the cycle in
one hour increments up to 24 hours.
œ:‹‚ 1 hour delay
œ:ƒ... 24 hours delay
To set Delay start:
Press On/Off button (. Select a
1.
cycle.
Press Delay button @ until the
2.
displayed time corresponds with
your requirements.
Press Start button P to activate
3.
Delay start.
To cancel Delay start:
Press Delay button @ until œ:‹‹
1.
is indicated on the digital
display 8.
Press Start button P to save
2.
setting.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
Wash cycle end
The wash cycle has ended when the
display 8 reads ‹‹:‹‹.
Auto power off
To save energy, the dishwasher is
turned off 1 minute after the wash
cycle ends.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
30
To change the setting:
Press the On/Off button (.
1.
Hold down the function key #
2.
and press the Start button P
until the display 8 indicates
š:‹x (x can be any number).
Release both buttons.
3.
Press the function key # until
4.
the display 8 indicates ˜:‹x.
Press the function key 3 until
5.
the display corresponds with your
requirements.
Press the Start button P.
6.
Switching off the appliance
Short time after the end of the wash
cycle:
Press On/Off button (.
1.
Turn off water supply.
2.
Remove the utensils when they
3.
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.