Zibro SC 1832 Manuel D'utilisation page 111

man_SC1832_uk.qxd 24-11-2009
NOTE!
• In the AUTO mode, the air conditioner can logically choose the mode COOL, FAN, HEAT and
DRY by sensing the difference between the actual ambient room temperature and the set
temperature on the remote controller.
• If the AUTO mode is not comfortable for you , the desired mode can be selected manually.
COOL, HEAT, and FAN ONLY Operation
1. If the AUTO mode is not comfortable, you may manually override the settings by using COOL, DRY,
HEAT (HEAT PUMP units only), or FAN ONLY modes by pressing button
2. Push the
most comfortable settings are 21ºC or above. When in HEATING mode, the most comfortable settings
are 28ºC or below.
3. Push the Fan button
4. Push the On/off button
settings. Push the On/off button
NOTE!
The FAN ONLY mode cannot be used to control the temperature. In this mode, only steps 1, 3 and
4 are applicable.
DRY Operation
1. Push the Mode button
2. Push the
3. Push the On/off button
mode. Push the On/off button
NOTE!
Due to the difference of the set temperature of the unit and the actual indoor temperature, the
Air Conditioner when in DRY mode will automatically operate many times without running the
COOL and FAN mode.
TIMER Operation
Push Timer on/off button (
set by the remote controller for the timer function is limited to a period of between 0.5 and less than 24
hours.
1. To set the STARTING time.
1.1 Push the Timer on button
the starting operation and the signal "Hr" will be shown on the Timer display area. You are now ready
to reset the time to START the operation.
1.2 Push the Timer on button
1.3 After setting the Timer on ,there will be half a second delay before the remote controller transmits the
signal to the air conditioner.
11:14 Pagina 111
or button ( and ) to set the desired room temperature. When in COOLING mode, the
to select the FAN mode of AUTO, HIGH, MED or LOW.
. The operation lamp lights and the air conditioner starts to operate per your
again to stop this unit operation.
to select DRY.
or button ( and ) to set the desired temperature from 21 C to 28 C.
. The operation lamp lights and the air conditioner starts to operate in the DRY
again to stop this unit operation.
and ) to set the on and off times of the unit. The effective operation time
, then the remote controller display shows ON TIMER, the last set time for
again to set desired unit start time.
.
4
111