Alecto DVC-154 Mode D'emploi page 26

5 RESET.
When contact with the camera is no longer possible and
you can no longer determine what the IP address or the port
number no longer corresponds, you can externally reset the
camera to restore the default factory settings.
There is a small key on the back of the camera. Reset is listed
here. Prick the button with a small stick or a piece of a paper
clip. When the camera is started, press and hold this button for
at least 10 seconds.
The camera can then only be accessed via Wifi Direct. Now
follow the registration process see section 3.
6 TO INSERT THE SD CARD.
At the side you'll find a slot for inserting a Micro SD card,
this card slot sits rather deep. You might have to use a small
screwdriver or tweezers to carefully press the card until it clicks
into the correct position.
26
IN 5V
RESET