AEG SCB61826NS Notice D'utilisation page 34

34 www.aeg.com
Problem
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the "Frostmatic" or
"Coolmatic", or after chang-
ing the temperature.
Water flows on the rear
plate of the refrigerator.
Possible cause
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "Frostmatic function"
or "Coolmatic function" is
switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the ap-
pliance is too low and the
ambient temperature is
too high.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
Solution
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "Frostmatic function"
or "Coolmatic function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Set a higher temperature. Re-
fer to "Operation".
Set a higher temperature. Re-
fer to "Operation"
Refer to "Operation" .
The compressor starts after a
period of time.
This is correct.