AEG S32500KSW1 Notice D'utilisation page 26

26 www.aeg.com
Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is
too high.
Possible cause
The product temperature
is too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regula-
tor is not set correctly.
The temperature regula-
tor is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Solution
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.