VINCENT SV-200 Manuel D'utilisation page 30

OPTICAL
S1
INPUT
8
7. DIGIT L IN: Optical/Coaxial
Connections for audio signals of source devices
with digital sound such as, for example, DVD
players. "Optical" for optical fibre connection
and "Coaxial" for connection via coaxial cable.
8. INPUT: input connectors
Here you find two stereo RCA inputs for the source
equipment with analogue stereo (line level) audio
output.
9. REC OUT: recording output
If desired, you can connect a recording device like
a CD recorder or a tape recorder to this output. The
stereo signal of this output is identical to the output
signal of the selected audio source at one of the pre-
amplifier INPUTs. It is independent of the volume set-
ting (3)(23), and the loudness setting (5).
10. PRE OUT: preamplifier outputs
With this pair of RCA connectors you can output the
preamplified stereo audio signal of the currently
selected source to power amplifier channels or an
active subwoofer.
Vincent
30
REAR VIEW
7
INPUT
STEREO POWER AMPLIFIER
SER NO.
COAXIAL
POWER CONSUMPTION 125W
S2 REC PRE
OUTPUT
9
10
11
SPEAKERS
Model:
SV-200
OUTPUT
OFF 1 2 3
DIMMER
12 13
11. SPEAKERS: Speaker connectors
Output sockets with screw clamps for connection of
one pair of loudspeakers. You can use loudspeaker
cables with 4 mm banana connectors. Please refer
to the precautions in the section "Installation" in case
two pairs of loudspeakers are connected.
12. Dimmer for the tube illumination
The setting of this switch affects the brightness of the
illumination of the tube display window (2).
13. POWER CONTROL (12V) OUTPUT
At these jack connectors the signals for the on/off
control (Power Control, Trigger) are emitted.
14. Voltage Selector:
The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information (p.
36, "Switching the Voltage")
15. AC 220-240V:
Power Connector with Fuse holder
To establish the power supply, connect the plugs of
the power cable to the device and to a suitable wall
outlet. The small plastic housing holds the fuse. Refer
to the security precautions.
14
VOLTAGE
SELECTOR
~ 115V: FUSE T2AL 250V
~ 230: FUSE T1AL 250V
L N
~ AC INLET 50/60Hz
15