Publicité
DMX MODE (DMX)
Three different DMX modes are available for selection: 5-channel, 19-channel and 27-channel (DMX 05CH, 19CH, 27CH). The setting is made as pre-
viously explained in section SETTING OPERATING MODE. You will find DMX channel assignment tables in the DMX CONTROL section of this manual.
Mode DMX 27CH
SLAVE MODE (Slave)
The setting is made as previously explained in section SETTING OPERATING MODE.
Connect the slave and the master unit (same model) with a DMX cable. Enable one of the standalone modes (Auto, Static) in the master unit. Now the
slave unit follows the master unit.
Mode
Slave
AUTO MODE (Prog1 - Prog10)
The 10 various auto programs consist of a sequence of fixed programmed colour, gobo and motion sequences.
Pressing the MODE button will take you to the selection menu for system settings (System Settings). Using the arrow buttons, select the menu item
"Mode" (dark background) and confirm by pressing ENTER. The digits which show the operating mode change their colour to red, and you can use
the + and - buttons to select the desired Auto operating mode. Confirm 2x with ENTER and select one of the 10 Auto programs (Prog1 - Prog10)
using the + and - buttons, confirm with ENTER and select the "AutoSpeed" menu item to adjust the program speed as required. Press ENTER to
confirm, and adjust the speed from 000 to 255 by using the + and - buttons. Confirm with ENTER and press the MODE button 3x to return to the
main display.
Mode
Auto
Auto Mode
Auto
Prog 8
AutoSpeed
225
STATIC MODE (Static)
In the same way as with a DMX control unit, the static mode allows you to adjust all functions such as Pan, Tilt, colour and gobo wheel, and strobe
directly on the device applying values from 000 to 255. Thus, an individual scene can be created without an additional DMX controller. Pressing the
MODE button will take you to the selection menu for system settings. Using the arrow buttons, select the menu item "Mode" (dark background) and
confirm by pressing ENTER. The digits which show the operating mode, change their colour to red, and you can use the + and - buttons to select the
desired static mode (Static). After you have confirmed with ENTER, the parameters can be selected using the arrow buttons (see list). Press ENTER.
The value of the parameter can now be changed using the + and - buttons. Confirm the input with ENTER. Once all of the parameters have been set
as required, press the MODE button several times to return to the main display.
Mode
Static
17
Publicité
