Publicité
Les langues disponibles
Les langues disponibles
Filter cleaning
When the programme is completed, the
warning indicator for filter cleaning turns on.
Water tank
If the water tank fills up while the programme
continues, the warning indicator starts flashing
and the machine goes into stand-by. In this
case, empty the water tank and start the
programme by pressing the Start / Stand-
by button. Warning indicator turns off and
programme resumes.
Filter drawer /Heat exchanger cleaning
When the programme is finished, the cleaning
symbol of the heat exchanger or filter drawer
may light up.
5.7 Starting the programme
Press the Start/Stand-by button to start the
programme.
Drying indicator will light up, indicating that the
programme has started.
5.8 Child Lock
The drying machine has a child lock which
prevents the programme flow from being
interrupted when the buttons are pressed
during a programme. When the child lock
is activated, all buttons on the panel except
the On/Off/Programme selection knob are
deactivated.
Press the End Time and Buzzer buttons
simultaneously for 3 buttons to activate the
child lock.
The child lock has to be deactivated to be able
to start a new programme after the current
programme is finished or to be able to interfere
with the programme. To deactivate the child
lock, keep the same buttons pressed for 3
seconds.
C
NOTE
•
When the child lock is activated, the child
lock warning indicator on the screen
turns on.
•
Child lock deactivates when the drying
machine is turned off and on by the On/
Off/Cancel knob.
When the child lock is active:
When the drying machine runs, or in stand-
by state, the indicator symbols won't change
upon changing the position of the programme
selection knob.
14
C
NOTE
•
When the drying machine runs and the
child lock is active, it beeps twice when
the programme selection knob is turned.
If the child lock is deactivated without
returning the programme selection knob
to its previous position, programme
will terminate due to the change in the
programme selection knob position.
5.9 Changing the programme after it
is started
You can change the programme you selected
to dry your laundry with a different programme
after the drying machine starts running
•
For instance, select Extra Dry programme
by turning the On/Off/Programme
selection knob to select Extra Dry instead
of Iron Dry.
•
Press the Start/Stand-by button to start
the programme.
Adding and removing clothes during
stand-by
If you want to add or remove clothes to/from
the drying machine after the drying programme
starts:
•
Press the Start/Stand-by button to put
the drying machine in Stand-by state. The
drying operation stops.
•
Open the loading door while in Stand-
by state, and close the door after you
remove or add laundry.
•
Press the Start/Stand-by button to start
the programme.
C
NOTE
•
Adding laundry after the drying operation
starts may cause the dried laundry inside the
machine to mix with wet laundry and leave
the laundry damp at the end of operation.
•
Adding or removing laundry during drying
may be repeated as many times as you
wish. But this operation continuously
interrupts the drying operation, and thus
increases programme duration and energy
consumption. So, it is recommended to add
laundry before the programme starts.
•
If a new programme is selected by turning
the programme selection knob while the
drying machine is in stand-by, the running
programme terminates.
Dryer / User Manual
Publicité
