Velleman PI600BN Mode D'emploi page 8

11. CHASSIS EARTHING
The chassis earthing lug should be connected to an earthing point, which will vary
depending on where the power inverter is installed. In a vehicle, connect the
chassis ground lug to the chassis of the vehicle. In a boat, connect to the boat's
grounding systems. In a fixed location, connect to earth.
12. CAUTION
In case of trouble with the AC output, e.g. short circuit, overload, etc... the
protection circuit will automatically cut off the output.
In such cases :
Store the inverter in the right environment :
(A) well-ventilated
(B) not exposed to direct sunlight or any other heat source
(C) inaccessible to children
(D) safe from water/moisture, oil or grease
(E) safe from flammable substances
Connecting the inverter in the wrong way will void the warranty.
13. MAINTENANCE
Very little maintenance is required to keep your inverter operating smoothly. Clean
the exterior of the device periodically using a damp cloth in order to prevent the
accumulation of dust and dirt. Tighten the screws on the DC input terminals
whenever you are cleaning the device.
PI600W // 12V & 24V
(A) switch off the power at once
(B) disconnect all devices
(C) check the connected devices
(D) you can use the devices again as soon as the problems
have been solved
7 VELLEMAN