Zibro S1825 Manuel D'installation page 56

1. Fit the Installation Plate
1. Fit the installation plate
tion plate.
2. If the wall is made of brick, concrete or the like, drill eight (8) 5mm diameter holes in the wall. Insert
Clip anchor for appropriate mounting screws
3. Fit the installation plate
NOTE
Fit the Installation Plate and drill holes in the wall according to the wall structure and
corresponding mounting points on the installation plate. (Dimensions are in "mm" unless
otherwise stated)
Indoor unit outline
Over 12 cm from the wall
45
Left rear side refrigerant
pipe hole Ø65
<
Outline of the Indoor Unit
Over 12 cm
from the
wall
Rear left Pipe
hole Ø65
Indoor
4
56
horizontally on structural parts of the wall with spaces around the installa-
on the wall with eight (8) type "A" screws
150 mm or more to ceiling
Installation plate
from the wall
90
Right rear side
refrigerant pipe
815
2.7 kW model
150 mm or more to ceiling
Over 12 cm
from the
40
270~370
Pipe hole Ø65
659 133
878
3.5 kW model 5.2 kW
Wall
Outdoor
≥5°
Fig. 6
.
150 mm or more to ceiling
Indoor unit outline
Over 12 cm
Over 12 cm from the
wall
Rear left Pipe
70
hole Ø65 hole Ø65
≤
2.7 kW model
150 mm or more to ceiling
Indoor Unit outline
Over 12 cm
from the
wall
wall
Rear right
Left refrigerant
pipe hole Ø65
Fig. 5
.
Installation Plate
Over 12 cm
from the
70 Pipe hole Ø65
750
3.5 kW model
Installation Plate
920
50
5.2 kW model
wall
Rear right
Over 12 cm
from the
wall
Right refrigerant
pipe hole Ø65