Bresser 9686100 Mode D'emploi page 22

7. Repeat steps 1 to 5 to adjust the basic settings or press the MENU button again to return to video
recording, photo shooting or playback mode.
NOTICE! To exit a menu item without making any changes, exit the entire menu by pressing
the MENU button then call up the menu again.
Menu item
Resolution
Loop Recording
WDR
G-Sensor / Gravity Sensing
Exposure
Motion Detection
Record Audio
Date Stamp
Table 1: Video recording settings menu
Menu item
Capture Mode
Resolution
Sequence
Quality
Sharpness
White Balance
Colour
ISO
Exposure
Anti-Shaking
22 / 52
Adjustment (s)
Set video resolution (1080FHD 1920x1080, 720P
1280x720, WVGA 848x480 or VGA 640x480).
Enable automatic recording (1, 3, or 5 minutes) or
disable (OFF). If active, non-write-protected re-
cordings will be overwritten when the storage me-
dium is full. If the function is deactivated, no more
recordings will be made when the storage medium
is full.
Activate Wide Dynamic Range function (ON) or
deactivate function (OFF).
Select sensor sensitivity (high, medium or low) or
deactivate function (OFF).
Set the exposure value (+2, +5/3, +4/3, +1, +2/3,
+1/3, 0 , -1/3, -2/3, -1, -4/3, -5/3, -2).
Activate Motion Detection (ON) or deactivate func-
tion (OFF). When Motion Detection is activated, a
video is automatically captured when motion is de-
tected depending on the loop value setting.
Activate Audio recording (ON) or deactivate func-
tion (OFF).
Overlay date stamp (ON) or hide date stamp
(OFF).
Adjustment (s)
Set the type of image recording (instant image
(single) or image with a time delay of 2 seconds, 5
seconds or 10 seconds (timer) after the shutter re-
lease).
Set the image resolution (12M, 10M, 8M, 5M, 3M,
2MHD, 1.3M or VGA).
Activate the Continuous-Advance function (ON) or
deactivate function (OFF). If the function is activ-
ated, 3, 5 or 10 images will be captured each time
you release the shutter.
Set the image quality (basic, normal or fine).
Set the sharpness of the image (strong, normal or
soft).
Set White Balance (fluorescent, tungsten, cloudy,
daylight or auto).
Set the colour (black, black and white or sepia).
Set the light sensitivity of the image sensor (400,
200, 100 or auto).
Set exposure value (+2, +5/3, +4/3, +1, +2/3,
+1/3, 0 , -1/3, -2/3, -1, -4/3, -5/3, -2).
Activate Anti-Shaking (ON) or deactivate function
(OFF).