Télécharger Imprimer la page

DeWalt DPD3100 Guide D'utilisation page 15

Publicité

Les langues disponibles

Les langues disponibles

1. Remove the filter screen (U) by grasping the
end and removing it from water inlet of
pump.
2. Clean filter by flushing it with water on both
sides.
3. Reinsert filter into water inlet of pump. Cone
side faces out.
note: Do not operate pressure washer without
filter properly installed.
To remove Tires
1. Using a 1/8" hex head wrench loosen set
screw in hub collar.
2. Slide hub collar from axle and remove the
tire.
STorAGE
Engine
Consult the engine instruction manual for the man u fac tur er's
recommendations for storage.
Pump
The manufacturer recommends using a pump protector/winter-
izer, such as D
WALT winterizer (DP80) when storing the unit
e
for more than 30 days and/or when freezing temperatures are
expected. D
WALT winterizer (DP80) is availabe at the store
e
where the pressure washer was purchased. If a pump protector/
winterizer is not available, RV antifreeze can be used as outlined in
the following steps.
note: Using a pump protector/ winterizer or RV antifreeze helps to
provide proper lubrication to the internal seals of the pump regard-
less of temperature or environment.
1. Obtain a funnel, 6 oz. (170 mL) of RV antifreeze and 16–36"
(40–91cm) of garden hose with a male hose connector attached
to one end.
CAUTION: risk of property damage. Use only rv antifreeze. Any
other an ti freeze is corrosive and can damage pump.
2. Disconnect spark plug wire.
U
3. Connect length of garden hose
to water inlet of pump.
4. Add RV antifreeze to hose as
shown.
5. Pull engine starter rope slow-
ly several times until an ti freeze
comes out of high-pressure hose
con nec tion of pump.
6. Remove
garden
water inlet of pump.
7. Reconnect spark plug wire.
Pressure Washer
1. Drain
all
water
pressure hose, coil it and store it
in cradle of the pressure washer
handle.
2. With nozzle pointed down and
the spray gun and wand in a
vertical position, squeeze trigger
to drain all water from spray gun
and wand. Store in gun holder.
3. Store chemical hose so it is protected from dam age.
4. If space is needed, handles may be removed and attached as
shown.
15
hose
from
from
high-

Publicité

loading