Christopeit Sport ET 6 Notice De Montage Et D'utilisation page 24

Error Message:
E1 (ERRoR 1):
Normal state: During workout, when the monitor did not get the count signal
from the gear motor more than 4 seconds and check under successive 3
times then the LCD will show E1.
Power on state: The gear motor will return to zero automatically, when the
signal of motor cannot be detected for more than 4 seconds then the gear
motor's driver will be cut off immediately and show the E1 on the LCD
display. All the other digital and function mark are blank, and the output
signals are cut off also.
Technical data of the current adapter
Model: AHEAD, JAD-0600500E
I/P: 220-240V~50Hz 0,1A max.
O/P: 6V = 500mA 3.0VA
LCD Workout Graphics
PRESET PRoGRAM PRoFILES:
PROGRAM 1
PROGRAM 1
MANUAL
MANUAL
PROGRAM 4
RoLLING
PROGRAM 7
RAMP
PROGRAM 10
RANDoM
PROGRAM 13
PRECIPICE
E2 (ERRoR 2): When the monitor read the memory data, if the I.D. code
is not correct or the memory IC damages then the monitor will show E2
immediately at power on.
E3 (ERRoR 3): After 4 seconds by start mode, the computer detects the
faulty motor did not leave the zero point then the LCD bar displays "E3".
Program 2
Program 2
STEPS
STEPS
Program 5
VALLEY
Program 8
MoUNTAIN
Program 11
PLATEAU
24
PROGRAM 3
PROGRAM 3
HILL
HILL
PROGRAM 6
FAT BURN
PROGRAM 9
INTERVALS
PROGRAM 12
FARTLEK