Fitting The Device Into The Frame; Intalling The Water Drainage System - Wine Master C18 Notice D'installation Et D'utilisation

32

2.3.2 FITTING THE DEVICE INTO THE FRAME

Position the air-conditioner in the
frame from inside the cellar
Check the seal between the wooden frame and the Winemaster. The electrical connection cable and the
PVC condensate tube are situated inside the cellar.
If the power cord is damaged, it should be replaced by the manufacturer, its SAV
or a person of similar qualifications.
2.3.3 INSTALLING THE WATER DRAINAGE SYSTEM
The container for collecting condensate is glued onto the cover. You are recommended to attach the pipe
when the cover is off.
Flow from the condensate collection
tray.
Tighten the collar using a universal
wrench or pliers.
Tighten the two screw/washer units at
the top
Push the PVC pipe on, being careful
to support the tray with the other
hand.
The pipe is well attached.
Tighten the two screw/washer units
on the side
Place the collar as close to the cover
as possible for better adhesion.
Refit the cover on the Winemaster
and tighten the 4 screws