Publicité
Assembly recommendations
Please pre-drill all screw connections in order to
avoid any damage to the wooden sections.
The following symbol in the instructions will indicate
when this is necessary:
To prevent the dropping of the glass door, tighten the allen screw of the braces firmly.
Note:
With the exception of the door element, a 2 cm deep groove must be located on the upper edge of the
elements. The groove on the lower edge is only 8 mm deep.
Supply air element with cable guide
The supply air element contains a 6 cm wide supply air slit,which must later be located under the sauna furnace.
Cable ducts were incorporated above
this slit which are to be used as follows:
R1:
for running cable from oven control system module
to the sauna oven
R2:
for running cable from oven control system module
to the control unit
R3 + R4:
reserve
Assembly variants
We recommend 2 building variants each time which have proved themselves to be particularly practical. Other
possibilities for the arrangement of the wall elements are also feasible, for which the following conditions are to be
followed:
The sauna furnace and the control unit are usually mounted on the supply air element
The wall element with the outgoing air opening must be configured diagonally to the
supply air opening, in order to guarantee optimal air circulation in the sauna aisle.
The supply air element can be installed left or right of the door.
With the exception of the supply air element, the wall elements do not have any specially
determined interior or exterior side.
Before installation, the door element can be turned so that later the door can open to
the left or right.
The sauna can also be built in its mirror image.
You should have the following tools to hand before beginning assembly.
Spring tape
Spirit level
measure
Mitre saw/
hand disk saw
Techn. Änderungen vorbehalten!
Drill
Universal cutter
Alle Maßangaben sind ca. Maße.
5
Elektric
screwdriver
Hammer
Spanner
Allen key
Copyright HRB 3662
Rubber mallet
Screwdriver
Publicité
