Operation; Daily Use - JUNO JCT14510S5 Notice D'utilisation

OPERATION

Switching on
Insert the plug into the wall socket.
Switching off
To turn off the appliance, turn the
temperature regulator to the "0" position.
Temperature regulation
The temperature is regulated automatically.
A medium setting is generally
the most suitable.
However, the exact setting
should be chosen keeping in
mind that the temperature inside
the appliance depends on:
• room temperature,
• how often the door is
opened,
• the quantity of food stored,
• the location of the appliance.

DAILY USE

WARNING! Refer to Safety
chapters.
Storage of frozen food
When first starting-up or after a period out
of use, before putting the products in the
compartment let the appliance run at least
2 hours on the higher settings.
In the event of accidental
defrosting, for example due to a
power failure, if the power has
been off for longer than the
value shown in the technical
characteristics chart under
"rising time", the defrosted food
must be consumed quickly or
cooked immediately and then
re-frozen (after cooling).
1. Turn the Temperature regulator toward
lower settings to obtain the minimum
coldness.
2. Turn the Temperature regulator toward
higher settings to obtain the maximum
coldness.
CAUTION! If the ambient
temperature is high or the
appliance is fully loaded, and the
appliance is set to the lowest
temperatures, it may run
continuously causing frost to
form on the rear wall. In this
case the dial must be set to a
higher temperature to allow
automatic defrosting and
therefore reduced energy
consumption.
Temperature indicator
For proper storage of food the refrigerator is
equipped with the temperature indicator.
The symbol on the side wall of the
appliance indicates the coldest area in the
refrigerator.
If "OK" is displayed (A), put fresh food into
area indicated by symbol, if not (B), adjust
the temperature controller to a colder
setting and wait 12 hours before checking
the temperature indicator again.
OK
A
OK
B
19