Bestron AGP1800 Mode D'emploi page 16

operAtion
- general
The grill is only intended for domestic
use, not for professional use.
1. Grill plate
2. Socket
3. Thermostat dial
4. Indicator light, temperature
5. Removable thermostat
6. Collecting groove
7. Drip tray
8. Non-slip feet
before first use
1. Remove the grill from the packaging, and remove all packaging materials.
2. Clean the grill plate before using the appliance for the first time (see 'Cleaning and maintenance').
The appliance may emit a little smoke and a characteristic smell when you switch it on for the first time.
This is normal, and will soon stop. Make sure the appliance has sufficient ventilation.
Do not touch the appliance if it falls into water. Remove the plug from the wall socket immediately. Do not
use the device again.
use
- preheating
1. Put the appliance on a level and heat-resistant surface.
2. Insert the thermostat fully into the grill-plate socket.
Only the supplied cable with thermostat may be used.
3. Put the plug in the wall socket.
4. Adjust the thermostat dial to the required temperature. The indicator light on the thermostat will illuminate
to show that the heating element has been switched on.
5. After waiting a few minutes check whether the indicator light is extinguished. Once the indicator light has
extinguished the appliance has reached the required temperature, and is ready for use.
During use the heating element will switch on and off to keep the temperature of the grill plate constant.
Consequently the indicator light will also occasionally be illuminated.
use
- grilling
1. Allow the grill plate to preheat (see 'Preheating').
2. If so required, grease the grill plate with a little oil.
3. Place the food you wish to grill on the grill plate.
4. Grill the food until it is cooked. Turn the food over occasionally whilst it is being grilled to ensure that both
sides are evenly cooked.
5. Remove the food from the grill plate and place on a plate. Take care! The food is hot.
6
7
8
16
instruction manual
2
5
1 3 5
4
8