Xo XORI36S Notice D'utilisation page 9

INSTALLATION INSTRUCTIONS
INSTALLATION - VENTED TO THE OUTSIDE
1. INSTALLATION:
- Remove the structure from the packa-
ging and remove the 2 screws A to sepa-
ratethe upper part from the lower part
(Fig.1).
- Position hole template on the ceiling
paying attention that the arrow is posi-
tioned on the same side as the appliance
controls (Fig.2).
Make 4, Ø8 holes in the ceiling and drive
in 3 screws without completely tighte-
ning them. Pay attention not to insert the
screw into the hole marked with an X on
the hole template (the screws and expan-
sion plugs must be suitable for the type
of wall).
- Take the upper part of the structure B
(Fig.3) and insert the 3 slots onto the 3
screws that are not completely tightened.
Rotate slightly to fit (Fig.3). Drive in the
fourth screw X and tighten the remaining
3 to allow definitive blocking of the upper
part ofstructure B.
- Take the lower part of the telescopic
structure C and insert it into the upper
Fig.3
Fig.1
Fig.2
B
- 9 -
A
B
X
B