JVC DLA-RS40 Manuel D'instructions page 51

Adjustments and settings in the menu (continued)
Mask
Off
2.5%
5%
Custom
Left
Right
Top
Bottom
Progressive
Auto
Off
[2-1] HDMI
Input
Standard
Enhanced
Super White
Level Check
0 235
255 16
Color Space
Auto
YCbCr (4:4:4)
YCbCr (4:2:2)
RGB
Control with HDMI
It hides the upper, lower, left and right borders of the screen with a black mask. Can be
individually adjusted vertically and horizontally. Please adjust to your preference.
Setting: Off, 2.5%, 5%, Custom
Not masked.
Compared to the original video images, around 2.5% around the video images are
masked.
Compared to the original video images, around 5% around the video images are masked.
Compared to the original video images, around 5% of the video images are masked on
the left side.
Settings: 0 ~ 5%
Compared to the original video images, around 5% of the video images is masked on the
right side.
Settings: 0 ~ 5%
Compared to the original video images, around 5% of the video images are masked at the
upper side.
Settings: 0 ~ 5%
Compared to the original video images, around 5% of the video images are masked at the
bottom side.
Settings: 0 ~ 5%
Interlaced signals (480i/576i/1080i) are converted to progressive signals. Interpolates
interlaced signal video images with video images from the surrounding. Please set to your
preference.
Settings: Auto, Off
It is automatically detected if the 24p video images, which can be seen in the film screens,
interlaced signals from the original video material or if they are the product of signal
conversion and are interpolated accordingly.
The interpolation of video images as interlaced video signals, e.g. video material is done.
(*) It can be set when the HDMI terminal is selected.
Sets the dynamic range of the input video images (scale). Dark and bright areas, which
are not matched to the range, might get brighter or darker. If you are unsure of the input
signal dynamic range, please check under "Level Check".
Settings: Standard, Enhance, Super White
It gets set if the dynamic image range of the gradation level of the input image is set to
16-235. In case of a video signal, please set it up here.
It is set if the dynamic range of the input video scale level is 0-255.If these are PC signals,
please set them here.
It is set if the dynamic range of the input video scale level is 16-255.Please set the output
to video equipment compatible with Super White for Super White-enabled DVD / BD etc.
You can confirm the dynamic range of the input signal.A pattern as shown in the
illustration is displayed in the four corners and center of the screen. Please compare the
dynamic range of input signal with this pattern illustration and confirm.
(*) The number in the illustration is the scale level. This number is not displayed. The
illustration of the gradation in the figure is accentuated for explanatory purposes It is
different from the actual scale level.
It sets the color space of the input signal.
Settings: Auto, YCbCr(4:4:4), YCbCr(4:2:2), RGB
YCbCr(4:4:4), YCbCr(4:2:2), RGB signals are automatically detected and configured.
Sets it if the input of the YCbCr(4:4:4) input video image signal is performed.
Sets it if the input of the YCbCr(4:2:2) input video image signal is performed.
It is set when the RGB video signals input is performed.
Configured communication of the HDMI equipment control
Settings: On, Off
ENGLISH
[Off]
[0]
[0]
[0]
[0]
[Auto]
[Standard]
[Auto]
[Off]
51