Hansgrohe AXOR Urquiola 11026000 Mode D'emploi page 4

6
Safety Notes
Gloves should be worn during installation to prevent
6
crushing and cutting injuries.
The shower system may only be used for bathing,
6
hygienic and body cleansing purposes.
The hot and cold supplies must be of equal pressu-
6
res.
Installation Instructions
• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart®
(flow limiter) located behind the aerator can be
removed.
• Prior to installation, inspect the product for transport
damages.
After it has been installed, no transport or surface
damage will be honoured.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
The product is exclusively designed for drinking water!
4
English
Symbol description
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 32
Adjustment
To adjust the hot water limiter on single lever
mixers, please see page 34. No adjustment
is necessary when using a continuous flow
water heater.
Do not use silicone containing acetic acid!
Dimensions (see page 31)
Flow diagram
(see page 31)

with EcoSmart®

without EcoSmart®
Spare parts (see page 36)
Operation (see page 35)
Hansgrohe recommends not to use as
drinking water the first half liter of water
drawn in the morning or after a prolonged
period of non-use.
Special accessories
Installation putty order as an extra
Cleaning
see enclosed brochure.
Test certificate (see page 36)