Thermotte; Door And Glass; Warranty; Advice On Lighting A Fire - Nordpeis N-29U Manuel D'installation

Thermotte™

The insulation plates (Thermotte -FIG 10) are classified
as "wear and tear" parts which will require to be
exchanged after some years.
The wear time will depend on the individual use of your
product. Nordpeis offers a one-year warranty on these
parts. After this, replacements can be purchased.
In case it is necessary to take out the insulation plates,
this is done in followieng order.
A. Baffle plate
B. Back plate left
C. Back plate right
D. Bottom front plate
E. Bottom plate left
F. Bottom plate right
Please note: Wood logs that are too long can cause
additional strain and crack the plates, due to the tension
created between the side plates.

Door and Glass

Should there be any soot on the glass it may be
necessary to clean it. Use dedicated glass cleaner, as
other detergents may damage the glass. (NB! Be care-
ful, even dedicated glass cleaner can damage the var-
nish on the door frame and the gaskets). A good advice
for cleaning the glass is to use a damp cloth or kitchen
roll paper and apply some ash from the burn chamber.
Rub around the ash on the glass and finish off with a
piece of clean and damp kitchen roll paper.
Attention! Only clean when the glass is cold.
Periodically, it may be necessary to change the gaskets
on the door to ensure that the burn chamber is air tight
and working optimally. These gaskets can be bought as
a set, usually including ceramic glue.
CERAMIC GLASS
CANNOT BE
RECYCLED
Ceramic glass should
be disposed of as resid-
ual waste, together with
pottery and porcelain
Recycling of ceramic glass
Ceramic glass cannot be recycled. Old glass, breakage
or otherwise unusable ceramic glass must be discarded
as residual waste. Ceramic glass has a higher melting
temperature, and can therefore not be recycled together
with glass. If mixed with ordinary glass, it would
damage the raw material and could, in worst case end
the recycling of glass. It is an important contribution to
the environment to ensure that ceramic glass does not
end up with the recycling of ordinary glass.
14
Packaging Recycle
The packaging accompanying the product should be
recycled according to national regulations.

7. Warranty

Use replacement parts recommended only by the
Any unauthorized modification of the appliance
without written permission of the Manufacturer
are prohibited.
For detailed description of the warranty conditions see the enclosed
warranty card or visit our website www.nordpeis.com
The CE mark is placed on the side of the insert.

8. Advice on lighting a fire

The best way to light a fire is with the use of lightening
briquettes and dry kindling wood. Newspapers cause
a lot of ash and the ink is damaging for the environment.
Advertising flyers, magazines, milk cartons and similar
are not suitable for lighting a fire. Good air supply is
important at ignition. When the flue is hot the draught
increases and door can be closed
Warning: NEVER use a lighting fuel such as petrol,
karosine, alcohol or similar for lighting a fire. This
could cause injury to you as well as damaging the
Warning: In order to avoid injuries, please be
aware that the surfaface may become hot during
operation.be hot and that extra care need to be
taken to avoid skin burn.
Use clean and dry wood with a maximum moisture
content of 20%. Humid wood requires a lot of air for the
combustion, as extra energy/heat is required for drying
the humid wood and the heat effect is therefore minimal.
This in addition creates soot in the chimney with the risk
of creosote and chimney fire.
In case of a chimney fire, close the door and air
supplies on the stove / insert and call the Fire
Brigade. After a chimney fire the chimney must in
all cases be inspected by an authorized chimney
sweeper before you use the appliance again.
GB
Warning!
Manufacturer.
Warning!
product.