EuroLite 50120035 Mode D'emploi page 9

The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The mirror ball should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the mirror ball. If you lack these qualifications, do not attempt the installation
yourself, but instead use a professional structural rigger. Improper installation can result in bodily injury
and.or damage to property.
The mirrorball has to be installed out of the reach of people.
Caution: Mirrorballs may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the mirrorball!
Before rigging make sure that the installation area has to hold a minimum of 30/40 kg (30/40 cm) point load.
For the mirror ball 30/40 cm, only the EUROLITE MD-1515 safety rotate motor, No. 50301300 or a safety
technical equivalent motor has to be used.
The mirrorball has to be connected via an appropriate installation (see above) with the motor. We
recommend to use the Chain for Mirrorballs up to 40 cm at 33 cm length, No. 50301600 or Chain for
Mirrorballs up to 40 cm, at 100 cm length, No. 50301605.
The mirrorball has to be secured via an appropriate safety chain. This chain has to be built and constructed
in a way that it can hold 12 times the weight for 1 hour without any harming deformation.
The installation material must never include abrading material e. g. steel cables in order to avoid
material wearing.
The length of the chain must never exceed 100 cm.
Install the mirrorball chain with the screw-on chain link at the installation eyelet of the mirrorball and tighten
the fixation screw.
Insert the fourth chain link of the mirrorball chain with the mirrorball in the screw-on chain link and tighten the
fixation screw.
For overhead use, always install a safety chain on the mirrorball that can hold at least 12 times the weight of
the installation. The safety chain must be slightly longer than the mirrorball chain. Pull the safety chain
through the attachment eyelet of the mirrorball and in the attachment eyelet of the motor.
Make sure that the rotation of the mirrorball is never slowed down or stopped by decoration material etc.
Make sure that no side forces can impact on the installation.
Please check in regular intervals, if the installation material (e. g. shackles, screw-on carabines or screw-on
chain links) or chain links have been deformed. Uninstall the mirrorball immediately in such a case.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
9/18 00041167.DOC, Version 1.1