Télécharger Imprimer la page

Simu T5 AUTO SHORT Notice Originale page 4

Masquer les pouces Voir aussi pour T5 AUTO SHORT:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
2
WIRING
N
L
PE
- 3 operators (max.) can be wired in parallel on one switch.
- Attach cables to prevent any contact with moving parts.
- If the motor is used outdoors and if the power supply cable is of the H05-VVF type, then run the cable in a UV-resistant
conduit, e.g. trunking.
- The motor can not be use with control devices such as: emergency power supply (ie: regulated power supply, power gene-
rating unit), triac, ex, ....). Please contact us.
3
POWER UP OF THE OPERATOR
>>
After the first two consecutive opening and closing of the shutter :
- The motor memorizes automatically the end limit ( up and down) positions.
- The "stop on obstacle" function is activated.
It is advised to carry out these two opening / closing cycles as soon as the product is installed.
4
CANCELLING THE AUTOMATIC SETTINGS
In the case of a new installation with this operator, it is advised to reset the motor according to the following proce-
dure:
- Press 3 consecutive times, for 1s each time, on the UP key. The motor runs briefly at each press.
- Press 3 consecutive times on the DOWN key. The first two press for 1s (the motor runs briefly at each press) and the third
press for 2s. The motor runs twice in the same direction.
>>
>>
1 s
1 s
5
OPERATION AND MAINTENANCE
- This drive is maintenance-free.
- Press the ▲ button on the control point to raise the motorised product.
- Press the ▼ button on the control point to lower the motorised product.
Tips and recommendations for use:
PROBLEMS
The motorised product does not operate. The overheating protection on the drive has been activated.
If the motorised product still does not work, contact a drive and home automation professional.
SIMU SAS, F-70103 GRAY as manufacturer hereby declares that the drive covered by these instructions when marked for input voltage 230V~50Hz and used
as intended according to these instructions, is in compliance with the essential requirements of the applicable European Directives and in particular of the
Machinery Directive 2006/42/EC and EMC Directive 2014/30/EU. The full text of the EU declaration of conformity is available at www.simu.com. Emmanuel
CARMIER, general director, GRAY, 11/2016.
>>
>>
1 s
POSSIBLE CAUSES
T5 AUTO SHORT
Blue
Black
Brown
Green/yellow
>>
>>
>>
1 s
1 s
>>
>>
>>
>>
2 s
SOLUTIONS
Wait for the drive to cool down.
OK
1
2
3
>>
2/2

Publicité

loading