Simu T5 AUTO SHORT Notice Originale page 3

These instructions apply to all T5 AUTO SHORT drive, the different versions of which are available in the current catalogue.
Field: T5 AUTO SHORT drive are designed to drive all types of roller shutters equipped with stop blocks and rigid links. The installer,
who must be a motorisation and home automation professional, must ensure that the drive product is installed in accordance with the
standards in force in the country in which it is installed such as EN 13659 relating to roller shutters.
Liability: Before installing and using the drive, please read operating and installation guide carefully. Please read these
instructions carefully before installing and using the drive. In addition to following the instructions given in this guide, the instructions
detailed in the attached Safety instructions document must also be observed. The drive must be installed by a motorisation and home
automation professional, according to instructions from SIMU and the regulations applicable in the country in which it is commissioned.
It is prohibited to use the drive outside the field of application described above. Such use, and any failure to comply with the instructions
given in this guide and in the attached Safety instructions document, absolves SIMU of any liability and invalidates the warranty. The
installer must inform its customers of the operating and maintenance conditions for the drive and must provide them with the instructions
for use and maintenance, and the attached Safety instructions document, after installing the drive. Any After-Sales Service operation
on the drive must be performed by a motorisation and home automation professional. If in doubt when installing the drive, or to obtain
additional information, contact a SIMU adviser or go to the website www.simu.com.
1
INSTALLATION
Instructions which must be followed by the drive and home automation professional installing the drive:
- Methods of wiring are given by national standards or IEC 60364 standard.
- Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
- The cable for the motor can be removed. If it is damaged, replace by the same. The cable may only be connected to the
motor by qualified personnel. The connector is to be assembled without damaging the contacts. The continuity of the earth
connection must be ensured.
- To receive information regarding the compatibility of the motor and the roller shutter or/and accessories, contact the roller
shutter manufacturer or SIMU.
Drilling the tube:
T5 AUTO SHORT 06/17
45 24
120
Assembly :
V.A.R
V.A.S
EASYLINK
OCTOEASY
MANDATORY
9910013
9910014
T5 AUTO SHORT
(230V~50HZ)
55
22,8
IP44
48*
4
1
2
3
1
EN - ORIGINAL INSTRUCTIONS
Z.I. Les Giranaux - BP71 - 70103 Arc-Les-Gray CEDEX - FRANCE
RCS VESOUL B 425 650 090 - SIRET 425 650 090 00011
364
387
5
2
1
2
2
5057712D
SIMU S.A.S. au capital de 5 000 000 €
n° T.V.A CEE FR 87 425 650 090
i
-20°C / +60°C
351
4 x Ø5 / 90°
Ø4,8 x 10
STEEL
4 Ø5 x 10
3
2
3
1
47
min.
1
1/2