Cleaning; Switching Off; Cleaning The Outside Of The Machine; Cleaning The Stainless Coffee-Holders - Victoria Arduino VA 358 WHITE EAGLE Manuel D'instructions

6.

CLEANING

6.1

SWITCHING OFF

To switch the machine off press the main switch
and set the machine to the "O" energy position.
6.2 CLEANING THE
OUTSIDE
OF THE MACHINE
The machine must be set to "O" power (switch
off and disconnector open) before any cleaning
operations are performed.
WARNING
Do not use solvents, chlorine-based prod-
ucts or abrasives.
WARNING
It is not possible to clean the machine using
water jets or standing it in water.
Cleaning the work area: remove the worktop,
lifting it up from the front and sliding it out.
Remove the water collection dish underneath and
clean everything with hot water and cleansers.
Cleaning the bottom: To clean all the chromi-
um-plated areas, use a soft, damp cloth.
64
6.3 CLEANING THE
STAINLESS
COFFEE-HOLDERS
The stainless coffee-holders are situated under
the delivery units.
NOTE: To clean proceed as follows:
coffee-holder.
holes are not obstructed but clean.
We recommend cleaning the coffee-holder
once a week.
6.4 CLEANING THE
UNIT WITH
THE AID OF THE
BLIND FILTER
The machine is pre-set for cleaning the delivery
unit with a specific washing powder.
The machine will initiate washing cycle which
consists in the circulation of hot water followed
by regular breaks.
We recommend carrying out a washing cycle at
least once a day with special cleansers.
CAUTION RISK OF INTOXICATION
Once the filter-holder has been removed,
repeat delivery operations a few times to
eliminate any cleanser residues.
To carry out the washing procedure, proceed as
follows:
blind filter.
powder and insert it into the unit filter-holder.
10 seconds.
Fig. 22
deliveries.
6.5 CLEANING
FILTERS AND
FILTER-HOLDERS
litre of hot water and immerse filter and filter-
holder (without its handle) in it leaving them to
soak for at least half an hour. Then rinse abun-
dantly with running water.