Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Parts and materials
Burner cap and grate
(Porcelain enamel on cast
iron)
Exterior finish
(Porcelain enamel)
Control knobs
(Plastic)
Exterior finish
(Stainless Steel)
Igniters
(Ceramic)
10
Suggested cleaners
• Non abrasive cleaners: Hot water and
detergent, Fantastic, Formula 409. Rinse
and dry immediately.
• Mild abrasive cleaners: Bon Ami® and
Soft Scrub®.
• Abrasive cleaners for stubborn stains:
soap-filled steel wool pad.
• Hot
sudsy
water:
rinse
thoroughly.
• Non abrasive cleansers: Ammonia,
Fantastic®, Formula 409®.
• Mild abrasive cleansers: Bon Ami®,
Ajax®, Comet®.
• Liquid cleaners: Kleen King®, Soft
Scrub®.
• Hot
sudsy
water:
rinse
immediately.
• If necessary, remove knobs (lift straight
up).
• Nonabrasive cleaners: Hot water and
detergent. Fantastic®, Formula 409®.
Rinse and dry immediately.
• Cleaner polish: Stainless Steel Magic®
to protect the finish from staining and
pitting; enhances appearance.
• Hard water spots: Household white
vinegar.
• Mild Abrasive Cleaners: Kleen King®
stainless steel liquid cleaner, Cameo®
aluminum & stainless steel cleaner, Bon
Ami®.
• Heat
discoloration:
Friend®.
• Carefully wipe with a cotton swab
dampened with water, ammonia or
Formula 409®.
• Gently scrape soil off with a toothpick.
Suggestions/Reminders
• The grates are heavy; use care when
lifting. Place on a protected surface.
• Blisters/crazing/chips are common due
to the extreme temperatures on grate
fingers and rapid temperature changes.
• Acidic and sugar-laden spills deteriorate
the enamel. Remove soil immediately.
• Abrasive cleaners, used too vigorously
or too often, can eventually mar the
enamel.
and
dry
• Acidic and sugar-laden spills deteriorate
the porcelain enamel. Remove soil
immediately.
• Do not use wet sponge or towel on hot
porcelain.
• Always apply minimal pressure with
abrasive cleaners.3
and
dry
• Do not soak knobs.
• Do not use abrasive scrubbers or
cleansers.
• Do not force knobs onto valve shaft.
• Pull knobs straight away from control
panel to remove.
• When replacing knobs, make sure
knobs are in the OFF position.
• Do not remove seats under knobs.
• Stainless steel resists most food stains
and pit marks provided the surface is
kept clean and protected.
• Never allow food stains or salt to remain
on stainless steel for any length of time.
• Rub lightly in the direction of polish lines.
• Chlorine or chlorine compounds in some
cleaners are corrosive to stainless steel.
Check ingredients on label before using.
• Always apply minimal pressure with
abrasive
graphics.
Bar
Keepers
• Avoid excess water on the igniter. A
damp igniter will prevent burner from
lighting.
• Remove any lint that may remain after
cleaning.
cleaners
especially
on
Publicité
Chapitres
Table des Matières
