Fulgor Milano F4PGK305S1 Guide D'utilisation page 11

Burner Use Suggestions
Use the right front, right rear or left rear burners for
simmering, or for cooking smaller quantities of food
requiring small cookware. Use the left front POWER Burner
for bringing liquids to a rapid boil, cooking large quantities
of food, or for deep-fat frying requiring large cookware.
The Burner Flames
Turn each burner on. Flames should be blue in color with no
trace of yellow. The burner flames should not flutter or blow
away from the burner. The inner cone of the flame should be
between 1/2" and 3/4" long.
Super Sealed Surface Burners
IMPORTANT
Do not obstruct the flow of combustion and ventilation air
around the burner grate edges.
Burner cap and gas spreader
Always keep the burner cap and gas spreader in place
when using a surface burner. A clean burner cap and
spreader will help prevent poor ignition and uneven flames.
Always clean the part after a spillover and routinely remove
and clean according to the "General Cleaning" section.
Burner base and injector
Gas must flow freely throughout the injector orifice to light
properly. Keep this area free of soil and do not allow spills,
food, cleaning agents or any other material to enter the
injector orifice opening.
Protect it during cleaning.
COOKTOP BURNER
Be sure when lighting the burner:
• Gas spreader pin is properly aligned with burner base
• Cap pin is properly aligned with gas spreader slot.
Burner ports
Check burner flames occasionally. A good flame is blue in
color, not yellow.
Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner
ports.
To Clean gas burner:
Before cleaning, make sure all controls are off and the
cooktop is cool.
1. Remove the burner cap from the burner base and clean
2. Remove the burner spreader. Clean the gas tube opening
3. Clean the burner base with a damp cloth (keep the gas
4. Replace the burner spreader and cap, making sure the
5. Turn on the burner. If the burner does not light, check cap
-1/2" to 3/4"
slot.
IMPORTANT
according to cleaning section.
and burner port according to cleaning section.
injector area free of cleaning agents and any other
material from entering the injector orifice).
alignment pins are properly aligned with the slots.
and spreader alignment. If the burner still does not light,
do not service the gas burner yourself. Contact a trained
repair specialist.
EN
7