Danby DAR044A6BSLDBO Guide D'utilisation Et D'entretien page 10

Operating Instructions
DOOR REVERSAL INSTRUCTIONS
If you fi nd the direction of opening the door on your appliance inconvenient, you can change it by following the steps
shown in the diagrams.
1. Remove the three (3) screws from the back of the worktop, lift the back of the worktop slightly and pull the worktop
forward, this will remove the worktop. See Figure 1.
2. Remove the left or right door strip cover (depending on which side you are moving the door to) and the left or right
hinge cover (on the door), then remove the two (2) upper hinge screws and remove the upper hinge. Loosen the up-
per door spindle and remove the door assembly. See Figure 2.
3. Remove the hinge pin from the door, move it to the other side of the door. See Figure 3.
4. Install the upper door spindle to the opposite side of the upper hinge, place the upper hinge onto the other side of the
cabinet, install the door strip cover and the hinge cover to the opposite side of where you removed it. See Figure 4.
5. Loosen and remove the adjustable foot and remove the two (2) screws around it. Remove the two (2) bottom hinge
screws, remove the bottom hinge. Reinstall the foot and two (2) screws where the bottom hinge used to be. Install the
bottom hinge where the foot used to be. See Figure 5.
6. Make necessary adjustments to the upper hinge and bottom hinge, reinstall the worktop in reverse order of removing
it.
To avoid personal injury to yourself and/or property, we recom-
mend someone assist you during the door reversal process.
CAUTION
7