Celestron Travel Scope 60 DX Guide De Démarrage Rapide page 3

10
Insert the barrel of the 20mm eyepiece into the diagonal and tighten
the set screw.
13
Remove the lens cap from the front of the telescope. To observe,
look through the eyepiece as shown. Focus the image by turning the
knobs below the focuser.
16
To move the scope up and down, rotate the entire pan handle
counterclockwise and use the handle to point the scope in the
direction you want to view. Rotate the pan handle clockwise to
lock it in place.
2 | E NG LISH
11
Remove the knurled nuts on the threaded posts at the focuser end
of the telescope tube.
14
For additional magnifi cation, you can use the included 3x Barlow
lens. Place the Barlow lens between the diagonal and the eyepiece.
12
Locate the fi nderscope and remove the plastic caps on the front and
back lens. Orient the fi nderscope so that the larger lens is facing
towards the front of the tube as shown. Place the fi nderscope over the
posts on the tube and replace the knurled nuts to secure it in place.
15
To move the scope right and left, hold a tripod leg with one hand
while the other hand uses the panning handle to move the scope.
The azimuth locking screw can be loosened or tightened to adjust the
tension to your preference.
For more information on this product or to download
the instruction manual, please visit the respective
product page on celestron.com
SOLAR WARNING: Never attempt to view the sun
through any telescope without a proper solar fi lter.
NEED ASSISTANCE?
Contact Celestron Technical Support
celestron.com/pages/technical-support
11-20