Panasonic CS-UZ9SKE Comment Utiliser L'appareil page 8

How to use
To switch between
powerful & quiet
POWERFUL QUIET
POWERFUL: To reach temperature quickly
• This operation stops automatically after 20
minutes.
QUIET: To enjoy quiet operation
• This operation reduces airfl ow noise.
To select operation mode
MODE
AUTO mode - For your convenience
• During operation mode selection the power
indicator blinks.
• Unit selects operation mode every 10 minutes
according to setting temperature and room
temperature.
HEAT mode - To enjoy warm air
• Unit takes a while to warm up. The power
indicator blinks during this operation.
COOL mode - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
To maximise comfort while
SLEEP
sleeping
(CANCEL)
• This operation provides you with a comfortable
environment while sleeping. It will automatically
adjust the sleep pattern temperature during the
activation period.
• The indoor unit indicator will dim when this
operation is activated. This is not applicable if the
indicator brightness has been manually dimmed.
• This operation is incorporated with the activation
timer (0.5, 1, 2, 3, 4, 5, 6, 7, 8 or 9 hours).
• This operation can be set together with single
timer or twin timer. Sleep operation has the
priority over OFF timer.
• This operation can be cancelled by pressing the
respective button when the sleep timer reaches
0.0h.
8
NORMAL
Remote control
display
OFF/ON OFF/ON OFF/ON
FAN SPEED
MODE AIR SWING
TEMP TEMP
SLEEP
ON ON SET SET
TIMER TIMER
OFF OFF CANCEL CANCEL
Auto OFF/ON button
Use when remote control is
misplaced or a malfunction
occurs. Raise the front panel:
• To use in AUTO mode, press
the button once.
• To use in COOL mode,
press and hold the button
until 1 beep is heard, then
release.
• To use in HEAT mode,
press and hold the button
until 1 beep is heard, then
release. And press again
until 2 beeps, then release.
• Press the button again to
turn off.
Remote control receiver
and indicator
(Green)
POWER
(Orange)
TIMER
Press and hold
for approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.