Panasonic CS-UZ9SKE Comment Utiliser L'appareil page 5

Do not use means to accelerate the
defrosting process or to clean, other than
those recommended by manufacturer.
Any unfi t method or using incompatible
material may cause product damage,
burst and serious injury.
Do not pierce or burn as the appliance is
pressurized. Do not expose the appliance
to heat, fl ame, sparks, or other sources
of ignition. Else it may explode and cause
injury or death.
Do not install the unit in a potentially
explosive or fl ammable atmosphere.
Failure to do so could result in fi re.
Do not insert your fi ngers or other
objects into the air conditioner
indoor or outdoor unit, rotating
parts may cause injury.
Do not touch the outdoor unit during
lightning, it may cause electric shock.
Do not expose yourself directly to cold air
for a long period to avoid excess cooling.
Do not sit or step on the unit, you
may fall down accidentally.
Remote control
Do not allow infants and small children
to play with the remote control to prevent
them from accidentally swallowing the
batteries.
Power supply
Do not use a modifi ed
cord, joint cord, extension
cord or unspecifi ed cord
to prevent overheating
and fi re.
To prevent overheating, fi re or electric
shock:
• Do not share the same power outlet with
other equipment.
• Do not operate with wet hands.
• Do not over bend the power supply
cord.
• Do not operate or stop the unit by
inserting or pulling out the power plug.
If the supply cord is damaged, it must be
replaced by the manufacturer, service
agent or similarly qualifi ed persons in
order to avoid a hazard.
It is strongly recommended to be installed
with Earth Leakage Circuit Breaker
(ELCB) or Residual Current Device
(RCD) to prevent electric shock or fi re.
To prevent overheating, fi re or electric
shock:
• Insert the power plug properly.
• Dust on the power plug should be
periodically wiped with a dry cloth.
Stop using the product if any abnormality/
failure occurs and disconnect the power
plug or turn off the power switch and
breaker.
(Risk of smoke/fi re/electric shock)
Examples of abnormality/failure
• The ELCB trips frequently.
• Burning smell is observed.
• Abnormal noise or vibration of the unit
is observed.
• Water leaks from the indoor unit.
• Power cord or plug becomes abnormally
hot.
• Fan speed cannot be controlled.
• The unit stops running immediately
even if it is switched on for operation.
• The fan does not stop even if the
operation is stopped.
Contact your local dealer immediately for
maintenance/repair.
This equipment must be earthed to
prevent electrical shock or fi re.
5