Panasonic CS-UZ9SKE Comment Utiliser L'appareil page 9

To select fan speed
FAN SPEED
(
Remote control display
AUTO
FAN
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
• To have low noise priority operation, select the
lowest fan speed ( ).
To adjust vertical airfl ow
AIR SWING
direction
(Remote control display)
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the fl ap
swings up/down automatically.
• Do not adjust the fl ap by hand.
To adjust horizontal airfl ow direction
• Manually adjustable.
Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after a
period of time with previous operation mode
and airfl ow direction.
• This control is not applicable when TIMER is
set.
Operation conditions
Use this air conditioner under the following temperature range.
Temperature (°C)
Max.
COOL
Min.
Max.
HEAT
Min.
DBT : Dry bulb temperature
)
Indoor
DBT
32
16
30
16
To set the timer
2 sets of ON and OFF timers are available to turn
ON or OFF the unit at different preset times.
1 2
ON
TIMER
OFF
1 Select ON or OFF timer Example:
• Each time pressed:
Cancel
2 Set the time
3 Confi rm
• To cancel ON or OFF timer, press
select respective
• If timer is cancelled manually or due to power
failure, you can restore the timer again by
pressing or
ON
then press .
SET
• The nearest timer setting will be displayed and
will activate in sequence.
• When ON Timer is set, the unit may start earlier
(up to 35 minutes) before the actual set time
in order to achieve the desired temperature on
time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For
clock setting, please refer to Quick guide.
Note
SLEEP
,
• Can be activated in all modes and can be
cancelled by pressing the respective button
again.
WBT DBT
23 43
11 5
- 24
- -10
WBT : Wet bulb temperature
3
SET
CANCEL CANCEL
OFF at 22:00
OFF
SET
TIMER
or
ON
or then press
CANCEL
to select respective
OFF
Outdoor
WBT
26
-
18
-11
to
OFF
.
or
9