Bushnell TROPHY CAM Série Manuel D'utilisation page 9

If both an external power source is connected and batteries are installed, the
Trophy Cam will be powered by the external power source.
When the batteries become weak, the low-battery indicator LED will glow
blue, indicating the batteries should be changed (pg 7, "Front View").
Inserting the SD Card
The Trophy Cams have 32MB internal memory, which can hold only about
20 photos (@ 5MP resolution). This is handy for testing and getting familiar
with the camera, but you will no doubt want to leave the camera unattended
for longer than a day, so using an SD card is recommended. Insert the SD
card (with the camera's power switch in the OFF position) before beginning
to operate the camera. Don't insert or remove the SD card when the power
switch is in the ON position.
The Trophy Cam uses a standard SD (Secure Digital) memory card to save
photos (in .jpg format) and/or videos (in .avi format). SD and SDHC (High
Capacity) cards up to a maximum 32GB capacity are supported. Before
inserting the SD card into the card slot after opening the camera's front
cover, please make sure that the write-protect switch on the side of the card
is "off" (NOT in the "Lock" position). The following describes how to insert and
remove the SD card:
• Insert the SD card into the card slot with its label side upwards (see
above). A "click" sound indicates that the card is installed successfully.
If the wrong side of the card is facing up, you will not be able to insert
it without force-there is only one correct way to insert cards. If the SD
card is not installed correctly, the device will not display an SD card icon
on the LCD in SETUP mode (the SD card icon displayed after switching
to SETUP mode will have a "lock" symbol inside it in it if the card is locked).
Formatting the SD card by using the Trophy Cam's "Format" parameter
before using it for the first time is recommended, especially when a
card has been used in other devices (see "Changing Menu Parameter
Settings" for details).
• To take out the SD card, just gently push
in the card (do not try to pull it out without
pushing in first). The card is released from
the slot and ready to be removed when you
hear the click. Be sure the camera's power is
switched OFF before inserting or removing
SD cards or batteries.
9