Bushnell TROPHY CAM Série Manuel D'utilisation page 25

Before leaving the camera unattended, please check for the following:
• Are the batteries or DC power supply inserted/connected with correct
polarity and is the power level is sufficient?
• Does the SD card have sufficient available space and is its write-
protection (lock) switch off?
• Is the Power switch in the ON position? (do not leave it in SETUP).
PLAYING BACK/DELETING THE PHOTOS/
VIDEOS
After you have setup, mounted and activated your Trophy Cam, you will of
course be eager to return later and review the images it has captured for
you. There are several different ways this can be done.
Reviewing Images Directly From the SD Card
This is the most popular method of viewing images. Since unmounting the
camera and taking it to your computer isn't very convenient, you may find it
easier to just take the card out. By removing the SD card (swapping it for a
new empty card if you like) and taking it to your home or campsite to view
the images by using an SD card "reader" (user supplied) connected to your
computer (some computers and TVs have a built in SD card slot), you can
leave the camera in place ready to capture more images. Once connected,
the card reader works the same way as described below-please read that
section if you have any problem finding your files.
Reviewing Images on an External Video Monitor
A TV monitor can also be used to play back pictures
(or videos) from the device. Connect a TV monitor or
a viewing device (such as a digital picture frame) that
has a standard composite video input (RCA jack)
to the Trophy Cam 's "TV Out" mini jack using the
supplied cable. Then:
• Put the power switch in SETUP mode (switch
to OFF first).
• Press the OK key. The most recently captured
image will be shown on the video monitor. For
video clips, press the SHOT (RIGHT) key to
start playing, press again to stop.
Cable from "TV Out"
25