Publicité
Les langues disponibles
Les langues disponibles
USE
• If the apparatus is equipped with the
following controls luminous:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes (*)
A
B
C
D
E
F
• By pressing key F for two seconds
(with the hood switched off ) the "clean
air" function is activated. This function
switches the appliance on for ten minutes
every hour at the first speed. As soon as
this function is activated the motor starts
up at the first speed for ten minutes. During this time key F and key C must flash at the
same time.
After ten minutes the motor switches off and the LED of key F remains switched on with
a fixed light until the motor starts up again at the first speed after fifty minutes and keys
F and C start to flash again for ten minutes and so on.
By pressing any key for the exclusion of the hood light the hood will return immediately
to its normal functioning (e.g. if key D is pressed the "clean air" function is deactivated
and the motor moves to the 2nd speed straight away. By pressing key B the function is
deactivated).
(*) The "automatic stop timer" delays stopping of the hood, which will continue func-
tioning for 15 minutes at the operating speed set at the time this function is activated.
• Active carbon/grease filter saturation:
- When button A flashes at a frequency of 2 seconds, the grease filters must be cleaned.
- When button A flashes at a frequency of 0.5 seconds, the carbon filters must be replaced.
After the clean filter has been replaced, the electronic memory must be reset by pressing
button A for approximately 5 seconds, until the light on the button stops flashing.
- 17 -
Publicité
