Start-Up - Pentair Flotec COMPAC 150 Manuel D'utilisation Et D'entretien

EN
USE AND MAINTENANCE MANUAL
CHAPTER 6
Start-up (see fig. 1 pag. 91)
WARNING
Use the pump for the applications listed on the nameplate.
INSTRUCTIONS FOR A SAFE PUMP START
The plug and connections should be protected by water splashes.
DANGER - ELECTRIC SHOCK RISK
The pump must not be used in or at swimming pools, garden ponds, etc.
when there are persons in the water.
The maximum suction level of 2 mm can be reached in manual mode only. If the level of the fluid to suck is below 20
mm, maximum suction, up to a residual level of 2 meters, can be attained more quickly by starting and topping the
pump 2 or 3 times.
AUTOMATIC MODE
PENTAIR FLOTEC ComPac pumps have an integrated floating switch. When the water reaches the start-up level, the
integrated floating switch automatically starts the pump.
When the water falls below the stop level, the integrated floating switch stops the pump.
1. Lower the front lever and place it
in location "AUT" (see Fig. 1).
MANUAL MODE:
The integrated floating switch is disabled so that the pump can run in continuous mode:
1. Lift the front lever and place it in
position "MAN" (see Fig. 1).
14
2. Place the pump in a stable
and straight position so that the
integrated floating switch is able to
move freely.
2. To start the pump, insert the
plug in a 230 V current socket.
3. To start the pump, insert the
plug in a 230 V current socket.