Technical Data - Pentair Flotec COMPAC 150 Manuel D'utilisation Et D'entretien

CHAPTER 3

Technical data

TECHNICAL DATA
Mains voltage / Frequency
Absorbed power
Type of protection / Insulation class
Delivery fitting
Maximum flow rate
Maximum head
Maximum depth of immersion
Power cable
Weight (without power cord)
Maximum dimension of pumped solid particles
Maximum temperature of the pumped fluid (in continuous mode)
Maximum number of starts per hour (uniformly distributed)
Minimum priming level (A)*
Minimum suction level (B)* (manual mode)
Start level (C)* (automatic mode)
Stop level (D)* (automatic mode)
Sound pressure level (Lpa) equal to or less than 70 dB(A)
Sound emission values obtained in conformity with the EN 12639 standard
(*) These data refer to Fig. 1, Pag. 91. Measurements are expressed in millimetres.
The maximum flow rates given are reached if the pump is used without the check valve supplied.
In outdoor fountains, garden ponds and similar places the pump is to be supplied through a residual current device
(RCD) having a rated residual operating current not exceeding 30mA. If these pumps are used in continuous mode
for ponds with fish, it is necessary to check them at regular intervals of 6 months (if the water contains aggressive
substances). It is also advisable to check the maximum dimension of particles recommended for the pump and take
the necessary measures to prevent the fish from being sucked into the pump.
USE AND MAINTENANCE MANUAL
ComPac 150 ComPac 200
230 V ~ 50 Hz 230 V ~ 50 Hz
300 Watt 650 Watt
IP 68 / F IP 68 / F
41,90 mm (1"1/4 M) 41,90 mm (1"1/4 M)
8.500 l/h 11.500 l/h
7 m 10 m
7 m 7 m
10 m H07 RN8-F
(10 m H05 RNF_ 10 m H07 RN8-F
N1080031)
3,6 Kg 4,8 Kg
5 mm 5 mm
40° C 40° C
30 30
15 mm 15 mm
2 mm 2 mm
140 mm 140 mm
30 mm 30 mm
EN
11