Installation - Pentair Flotec COMPAC 150 Manuel D'utilisation Et D'entretien

EN
USE AND MAINTENANCE MANUAL
CHAPTER 4
Installation (see Fig. 1-3)
DANGER - ELECTRIC SHOCK RISK
When installing, please ensure electropump is disconnected from electrical supply. Pumps in
this series are not suitable for use in a swimming pool and the relevant cleaning and servicing
operations.
DANGER
To prevent possible injuries to people, avoid inserting hands into the mouth of the pump if this is
connected to the electrical power supply.
Pentair DPC pumps come with a check valve that prevents the delivery pipe from being drained and the fluid from
recirculating.
If the pump is fixed in a permanent location with rigid pipes, it is advisable to install a quick closing fitting in the
most convenient location to facilitate cleaning and maintenance.
The dimensions of the collection chamber should allow the insertion of the pump and reduce to the minimum the
start- up operations per hour (see LIMITATIONS - Technical data).
Use the handle provided to transport or lift the pump.
To use the pump for temporary applications, install a flexible pipe and connect it to the pump using a pipe holder. To
immerse the pump, use a rope and fix it to the handle.
The pumps used in ponds, small lakes, fountains or similar installations or close to them should have a safety switch.
Contact a specialised electrician.
CONNECTION OF THE DELIVERY PIPE
1. Remove the part that is not being
used from the standard fitting
cutting it with a knife.
12
The fitting supplied with PENTAIR FLOTEC ComPac pumps can be adapted
A
to the dimensions of the pipe used.
To connect a threaded pipe or a 3/4" (19 mm) quick closing fitting, tighten it
directly on the threaded part (location a).
B
When using a Ø 25 mm (1") pipe, cut the stage that is not being used at the
correct height (up to point b).
When using a Ø 32 mm (1 1/4"), cut the stages that are not being used at the
C
correct height (up to point c).
2. Tighten the standard fitting on
the pump.
3. Connect the pipe to the standard
fitting