Bosch PushDrive Notice Originale page 25

Total vibration values a (triax vector sum) and uncertainty K determined according to
h
EN 62841-2-2:
Screwdriving: a < 2.5 m/s
h
The vibration level and noise emission value given in these instructions have been meas-
ured in accordance with a standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary estimation of vibration and
noise emissions.
The stated vibration level and noise emission value represent the main applications of
the power tool. However, if the power tool is used for other applications, with different
application tools or is poorly maintained, the vibration level and noise emission value
may differ. This may significantly increase the vibration and noise emissions over the
total working period.
To estimate vibration and noise emissions accurately, the times when the tool is
switched off or when it is running but not actually being used should also be taken into
account. This may significantly reduce vibration and noise emissions over the total work-
ing period.
Implement additional safety measures to protect the operator from the effects of vibra-
tion, such as servicing the power tool and application tools, keeping their hands warm,
and organising workflows correctly.
Fitting
Before any work on the tool (e.g. maintenance, tool change, etc.) as well as dur-
u
ing transport and storage, set the rotational direction switch to the middle posi-
tion. There is a risk of injury from unintentionally starting the tool by applying pres-
sure to the spindle.
Charging the battery (see figure C)
Do not use any other charger. The supplied charger is matched to the lithium-ion
u
battery that is fitted in your power tool.
Note: The battery is supplied partially charged. To ensure full battery capacity, fully
charge the battery in the charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without reducing its service life. Inter-
rupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by the "Electronic Cell Pro-
tection (ECP)". When the battery is discharged, the power tool is switched off by means
of a protective circuit: The application tool no longer rotates.
Bosch Power Tools
2 2
, K = 1.5 m/s
English | 25
1 609 92A 4TP | (11.01.2019)