Technical Data; Technical Description - LA NORDICA FLO' Manuel Utilisateur

TECHNICAL DATA

Definition in according to:
Constructive system
Nominal thermal power in kW
Efficiency in %
smoke outlet diameter in mm
Chimney height ≥ (m) - dimension (mm)
Depression by rating calorific value (mm H
Hourly consumption in kg/h (wood with 20% humidity)
CO measured at 13% oxygen in %
Exhaust gas emission in g/s - wood
Exhaust gas temperature in °C - wood
Hearth opening size in mm (W x H)
Hearth size in mm (W x H x D)
Oven size in mm (W x H x D)
Type of grill
Height in mm
Width in mm
Depth in mm
Weight in kg
Fire prevention safety distances
m riscaldabili (30 kcal/h x m
3
Electric consumption (W) max
(*) The proposed value are indicative. The installation must, in any case, be sized and verified according to the general calculation method in UNI
EN13384-1 or by another method of proven efficiency.
(**) For those buildings in which the thermal insulation does not correspond to the instructions on heat protection, the heating volume of the product
is: favourable type of building (30 kcal/h x m
With thermal insulation in accordance with the regulations regarding energy saving, the heated volume is greater. With temporary heating, in
the event of interruptions which last more than 8 hours, the heating capacity is reduced by about 25%.
The declared technical data have been achieved by burning beech wood class "A1" according to the requirement UNI EN ISO 17225-5 and wood
moisture content less than 20%. By burning a different kind of wood the efficiency of the product itself could change and some specific adjustments
on the appliance could be needed.

TECHNICAL DEsCRIPTION

Wooden logs are used as fuel. The appliance works as an intermittent operating appliance.
The appliance is made up of a steel chamber completely soldered and hermetic. The hearth is coated by single cast iron sheets and refractory
plates (Nordiker).
The appliances are equipped with an integrated air circuit for the recovery of the heat made up of a galvanized steel carter external to the
heating body.
The insert is equipped with a sight door with ceramic glass (resistant up to 700°C). This allows a charming sight on burning flames. Moreover,
in this way, any possible leak of sparks and smoke is avoided. Under the hearth grating there is a easily extractable ash drawer, also when the
appliance works.
ACCEssORIEs
The heating of the room occurs:
a) by convection: the passage of air through the coating and the covering hood releases heat in the room.
b) by radiation: through the sight glass and the steel body, heat is radiated into the room.
The device is equipped with registers of primary and secondary air, with which it is possible to adjust the combustion air.
1A - PRIMARY air register
(Picture
With the air register located under the door of the hearth (on the left), it is possible to adjust the air flow through the ash drawer and the
grating in direction of the fuel. The primary air is necessary for the combustion process during the ignition. In order to open the passage of
primary air the lever should be completely pulled.
22
O)
2
)
3
); less favourable type of building (40 kcal/h x m
3
POKER
SERIES
6)
GLOVE RING Ø 120mm air fitting ventilation additional
SERIES
ENgLIsH
FL Ò
EN 13240
1
8,3
85
150
(*) 4 - 200x200 Ø200
12 (1,2 mm H O)
2
2,3
0,09 - (1136 mg/Nm )
3
5,9
233
326 x 347
300 x 400 x 360
/
Movable - flat
1200
678
560
145
FIRE SAFETY
Chapter
238 (**)
50
); unfavourable type of building (50 kcal/h x m
3
SERIES
).
3