Table des Matières
Publicité
LED indicator
Témoin a diode
Indicador LED
*NOTE: The provided scales and numbers on the length and width controls are for reference only and
do not represent actual sewing parameters of length and width.
*REMARQUE: les échelles et les nombres sur les commandes de longueur et de largeur ne sont
fournis que pour référence et ne représentent pas les paramètres réels de longueur et de largeur.
*NOTA: Las escalas y números provistos en los controles de largo y ancho son sólo para referencia y
no representan los parámetros actuales de costura de largo y ancho.
CONTROL PANEL FUNCTIONS
Pattern selection buttons
Turn on the power switch and the LED indicator above the straight
stitch pattern will be lit. At this point you may sew Straight Stitch.
To select other patterns, push the pattern selection button to the
right of the row that contains your desired pattern. Stop when
the LED indicator above your pattern is lit.
Stitch length and width/needle position controls
Your sewing machine will produce most of your stitching
requirements at an Auto/Default Stitch Length and Width. When
a pattern is selected, it will automatically sew at default settings
of stitch length, width and needle position for straight stitch.
Auto (preprogrammed) default settings are easily determined
by moving the Stitch Length and Width / Needle Position Control
Knob. The LED Indicator next to the Control will light without
blinking and a beep will sound indicating you are at the Auto /
Default Position.
Once you have determined the Auto / Default position you can
manually change the length, width or straight stitch needle
postition according to your preference. Starting at the Auto
position, slide the control knob left or right to locate each of the
potential adjustments. At each manual adjustment point, the
LED will blink 3 times and a beep will sound.
Note: Instructions for manually changing the Straight Stitch
Needle Position are contained in the "Other Information" Section.
Notes: 1. Some patterns offer more opportunities for manual adjustments than others.
2. An alternate method of determining available adjustments is to move the control knobs while sewing slowly.
28
LED indicator
Témoin a diode
Indicador LED
Pattern selection buttons
Touches de sélection de motif
Botones de selección de patrón
Stitch length control *
Longueur de point *
Control longitud puntada *
Stitch width/needle position control *
Commande de largeur de point/position d'aiguille *
Control de ancho de puntada/posición de aguja *
Publicité
Table des Matières
