Technical Data; Technical Description - Nordica ITALY TERMO BUILT-IN-DSA Manuel Utilisateur

TECHNICAL DATA

Definition: in accordance with
global thermal power in kW
Nominal thermal power in kW
Power given back to water in kW
Power given back to the room in kW
Hourly wood consumption in kg / h (wood with 20% humidity)
Efficiency in %
CO measured at 13% oxygen in %
smoke outlet diameter in mm
Chimney height - dimension in mm
Fluid contents of the exchanger in l (litres)
Chimney draught in Pa (mm H
Boiler connections (Ø)
Automatic discharge pipe diameter (Ø)
Exhaust gas emission in g/s – wood
Exhaust gas temperature in °C - wood
Optimal working temperature in °C
Max. working pressure in bar
Hearth opening size in mm (W x H)
Hearth size in mm (W x H x D)
Oven size in mm (W x H x D)
Type of grill
Height in mm
Width in mm
Depth in mm
Weight in kg
Fire prevention safety distances
Heatable m (30 kcal/h x m
3
Electric consumption (W)
(*) 200 mm diameter can be used with flue of no less than 6 m. The proposed value are indicative. The installation must, in any case, be sized and verified
according to the general calculation method in UNI EN13384-1 or by another method of proven efficiency.
(**) For those buildings in which the thermal insulation does not correspond to the instructions on heat protection, the heating volume of the product is:
favourable type of building (30 kcal/h x m
With thermal insulation in accordance with the regulations regarding energy saving, the heated volume is greater. With temporary heating, in
the event of interruptions which last more than 8 hours, the heating capacity is reduced by about 25%.
IMPORTANT: The power of the connected heating system must be proportional to the power transferred to the water by the thermoproduct;
a charge which is too low does not allow regular oven operation, while a charge which is too high prevents adequate radiator heating.
The declared technical data have been achieved by burning beech wood class "A1" according to the requirement UNI EN ISO 17225-5 and wood
moisture content less than 20%. By burning a different kind of wood the efficiency of the product itself could change and some specific adjustments
on the appliance could be needed.

TECHNICAL DEsCRIPTION

La NORDICA thermocookers are ideal for holiday flats and weekend houses or as auxiliary heating all year round.
Wooden logs are used as fuel. The appliance works as an intermittent operating appliance.
The thermocooker is composed of galvanised steel sheet plates, enamelled cast iron and thermoradiant ceramic. The furnace is found inside
the boiler made with 4 mm thick steel and reinforced with welded nails. The water from the heating system, which absorbs the heat produced
in the furnace, circulates in the boiler. Inside the furnace, there is a height-adjustable flat grill.
The furnace is equipped with a panoramic door with ceramic glass (resistant up to 700°C). This allows a fascinating view of the burning flames.
In addition, in this way there is no possibility of sparks or smoke escaping.
Crystal and polished stainless steel facing. Possibility to fit between furniture.
ITALY TERMO BUILT-IN DSA
28
O)
2
(expansion vessel Open - Closed)
)
3
); less favourable type of building (40 kcal/h x m
3
ACCEssORIEs CHROME PLATED OVEN GRILLE
); unfavourable type of building (50 kcal/h x m
3
SERIES
ENgLIsH
ITALY TERMO - BUILT IN - DsA
EN 12815
22,2
18,4
15,1
3,3
5,1
83
0,12
160 S/P
5m – 220 x 220 Ø 220
22
12 (1,2)
1" F gas
½" M gas
21
174
70 -75
VEA 1,5 bar - VEC 3 bar
233 x 160
257 x 350 x 407
307 x 418 x 430
Movable - flat
853
996
730
283
Chapter sAFETY
527
-
POKER
SERIES
).
3
GLOVE
SERIES