RIDGID RD80702 Manuel D'utilisation page 15

Nettoyeur haute pression à l'essence
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION
For short range detergent application:
With the Dual Power Soap Nozzle installed on the spray
wand and the engine turned off, push the Dual Power Soap
Nozzle down as far as it will go.
Before shutting off the engine:
 Place the injection hose in a bucket of clean water.
 Flush for 1 - 2 minutes (spray clear water through the
spray wand).
 Shut off the engine.
NOTE: Shutting OFF ( O ) the engine will not relieve pressure
in the system. Pull trigger to release water pressure.
RINSING wITH THE PRESSURE wASHER
 Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Remove the nozzle by placing hand over nozzle then
pulling back the quick-connect collar.
 Select the right nozzle for the job:
• Use medium pressure nozzle (green) for items such as
a car or boat.
• Use higher pressure nozzle for jobs such as stripping
paint and degreasing the driveway. When using these
nozzles, test a small area first to avoid surface damage.
 Start at the top of the area to be rinsed and work down,
overlapping the strokes.
MOVING THE PRESSURE wASHER
See Figure 22.
NOTE: Never lift or carry this product using the moving
handle.
 Raise the handle.
 Turn the pressure washer off.
 Tilt the machine toward you until it balances on the wheels
then roll the machine to the desired position.
11 - English

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rd80905

Table des Matières