Exo Terra Reptile Dome NANO Mode D'emploi page 5

support base should not be removed!
5. Allow the adhesive tape bond to cure for 24 hours! Let the light
bracket rest on the terrarium mesh for 24 hours to allow the
tape bond to cure properly before the dome is suspended and
the weight of the dome can exert pressure on the support base.
INSTALL LIGHT AFTER 24 HOURS TO ALLOW THE TAPE BOND
TO CURE PROPERLY
6. Place the hanger in the designated holes on both sides of the
lamp fitting.
7. Remove the first rubber washer, slide the ring of the fixture's
support over the rod of the Light Bracket, then replace the first
rubber to secure the fixture's support tightly in between both
rubber stoppers.
8. Adjust the position of the Exo Terra® Reptile Dome NANO by
moving the rubber washers.
9. Adjust the height and tighten the screw of adhesive supporting
base when the Exo Terra Reptile Dome NANO is suspended
above the terrarium at the desired height.
10. Ensure that the light's focal point is not positioned above any
plastic parts of the terrarium or screen cover to prevent damage.
11. Screw light bulb into the Exo Terra Reptile Dome NANO (follow
maximum wattage guidelines: 40W Max.). TIP: apply a thin layer
of petroleum jelly to the threads on the base of the light bulb
before screwing it in. This will make it easier to unscrew the bulb
when it is time to replace it.
INSTALL LIGHT AFTER 24 HOURS TO ALLOW THE TAPE BOND TO
CURE PROPERLY
NOTE : FAILURE OF PROPER TAPE BONDING MAY BE ATTRIBUTED TO
ONE OF FOUR ISSUES:
8
1. Poor surface preparation and/or application.
2. Poor adhesive contact: exposed adhesive side of tape being
touched or contaminated.
3. Insufficient pressure being applied.
4. Lamp hung too soon, tape not fully cured.
GUARANTEE
This product is guaranteed for defective parts and workmanship
for a period of 2 years from the date of purchase. This guarantee is
valid with proof of purchase only. The guarantee is limited to repair
or replacement only and does not cover consequential loss, loss or
damage to livestock and personal property or damage to animate or
inanimate objects, irrespective of the cause thereof. This guarantee
is valid only under normal operating conditions for which the unit
is intended. It excludes any damage caused by unreasonable use,
negligence, improper installation, tampering, abuse or commercial
use. The warranty does not cover wear and tear or parts which
have not been adequately or correctly maintained. THIS DOES NOT
AFFECT YOUR STATUTORY RIGHTS.
RECYCLING
This item bears the selective sorting symbol for waste
electronic and electrical equipment (WEEE). This
means that the product must be handled pursuant
to European Directive 2012/19/EU in order to be
recycled or dismantled to minimize it's impact on
the environment. For further information please
contact your local or regional Authorities. Electronic
products not included in the selective sorting process are potentially
dangerous for the environment and human health due to the
presence of hazardous substances.
SERVICE
If you have any problems or questions about the operation of this
product, please let us try to help you before you return the product
to your dealer. Most problems can be resolved in store, but in the
unlikely event it cannot, please return the unit with a valid proof
of purchase to the retailer for a replacement under the two year
warranty. When you call (e-mail or write) our Customer Service
Department, please have all relevant information such as model
number and/or part numbers available, as well as the nature of the
problem:
Customer Service and Authorized Warranty Repair Service:
U.K.:
Rolf C. Hagen (UK) Ltd.
California Dr. Whitwood Industrial Estate
Castleford, West Yorkshire WF10 5QH
mail to: http://faq.hagencrm.com/?uk
Helpline Number 01977 521015. Between 9:00 AM and 5:00 PM,
Monday to Thursday and 9:00 AM and 4:00 PM on Friday (excluding
Bank Holidays).
Germany:
HAGEN Deutschland GmbH & Co. KG, Lehmweg 99-105, 25488 Holm
Service-Hotline: +49 (0) 4103 / 960-2000
Montag – Freitag von 9:00 – 16:00 Uhr
mail to: kundenservice@rchagen.com
Spain:
Rolf C Hagen España, S.A., P.I. L'Alteró, 46460 Silla (Valencia)
mail to: info@hagen.es
Malaysia:
Rolf C.Hagen (Sea) Sdn.Bhd.
Lot 14A, Jalan 3A, Kawasan Perusahaan
Cheras Jaya, Balakong 43200 Cheras,
Selangor Darul Ehsan, Malaysia.
Tel: 603-9074 2388
Fax: 603-9074 2389
mail to: customer.service-sea@rchagen.com
For general information on our whole product range, explore our
websites at: www.exo-terra.com or www.hagen.com.
Distributed by:
Canada: Rolf C. Hagen Inc., Montreal, QC H9X 0A2
U.K.: Rolf C. Hagen (U.K.), W. Yorkshire WF10 5QH
Germany: HAGEN Deutschland GmbH & Co. KG, 25488 Holm
Spain: Rolf C Hagen España, S.A. P.I. L'Alteró, 46460 Silla (Valencia)
Malaysia: Rolf C. Hagen (SEA) SDN, 43200 Cheras, Selangor D.E.