Craftsman CMXPTSG1014NB Guide D'utilisation page 10

REMOVE SANDING PAD
1. Push in on the spindle lock button
and rotate the spindle until you hear
the spindle lock into position. Loosen
and remove the sanding pad
spinning the pad in a
counterclockwise direction.
NOTICE: If the sanding pad will not
come loose, there are 2 holes on either
side of the spindle lock button .
2. Place the end of a #2 Phillips
screwdriver (not included) into one of
the holes and push in on the spindle
lock button . You can hold the
4
screwdriver and push in the spindle
lock button 4 with the same hand.
Using your other hand, loosen and
remove the sanding pad
spinning the pad counterclockwise.
4
2 by
4
2
2 by
2
4
4
ENGLISH
PUSH
4
9