Cycle Selection Charts - Inglis IPU5846 Guide D'utilisation Et D'entretien

To check water temperature
1. Run hot water at the faucet closest to your dishwasher for at
least 1 minute.
2. Place a candy or meat thermometer in a glass measuring
cup.
3. Check the temperature on the thermometer as the water is
running into the cup.
Additional efficiency tips
To save water, energy and time, do not rinse dishes before
putting them into the dishwasher.
Use a low energy, quick, or short cycle whenever possible.
These cycles use less hot water and energy than a normal
cycle.
Use a delay feature (on some models) to run your dishwasher
during off-peak hours. Local utilities recommend avoiding
heavy usage of energy at certain times of day.
During the summer, run your dishwasher at night. This
reduces daytime heat buildup in the kitchen.
Use the energy-saving dry option whenever possible. Allow
longer drying times (overnight) when using these options. Use
a rinse aid to improve drying.
Use cycles or options that add extra heat to the wash or rinse
portion of the cycle only when needed.
Run your dishwasher with full loads. Run a rinse cycle after
meals until the dishwasher is full.
If your home is equipped with a water softener, you may want
to avoid starting the dishwasher during the regeneration of
the softener, since this may contribute to poor wash
performance.

Cycle Selection Charts

Select the wash cycle and options desired and press START/
RESUME. The dishwasher starts filling once you press START/
RESUME, unless you select a delay wash. You can select an
option as the machine is filling.
After a wash cycle, the dishwasher remembers the options used
and uses the same options in the next wash cycle unless new
options are selected or Cancel/Drain is selected.
A " " shows what steps are in each cycle. Your model may have
some or all of the cycles shown.
Temperatures indicate where extra heat is added.
Water usage is shown in U.S. gallons/liters.
These models meet the ENERGY STAR
efficiency.
Cycle time includes dry time. An asterisk ( * ) by the cycle time
indicates the cycle time might be longer depending on the
temperature of the water entering the dishwasher. The cooler the
water, the longer the cycle time. If the water is already hot
enough, the cycle time will be as shown.
10
®
guidelines for energy
Pots & Pans
Use this cycle for hard-to-clean, heavily soiled pots, pans,
casseroles, and regular tableware.
Use both detergent dispenser sections.
Pre- Rinse Main Rinse
Wash Wash
140°F 140°F
(60°C) (60°C)
Heavy wash
Use this cycle for loads with heavy food soil.
Use both detergent dispenser sections.
Pre- Rinse Main Rinse
Wash Wash
Normal wash
Use this cycle for loads with normal amounts of food soil. (The
energy-usage label is based on this cycle.)
Use covered detergent dispenser section.
Pre- Rinse Main Rinse
Wash Wash
Light wash
Use this cycle for prerinsed or lightly soiled loads.
Use covered detergent dispenser section.
Pre- Rinse Main Rinse
Wash Wash
Purge † Final Dry Time
Rinse (min)
140°F 87*
(60°C)
†
Purge Final Dry Time
Rinse (min)
140°F 72*
(60°C)
Purge † Final Dry Time
Rinse (min)
140°F 61*
(60°C)
Purge † Final Dry Time
Rinse (min)
140°F 58*
(60°C)
Water
Usage
(gal/L)
8.6/32.6
Water
Usage
(gal/L)
6.9/26.1
Water
Usage
(gal/L)
4.8/18.0
Water
Usage
(gal/L)
4.8/18.0